Step 1 complete
Well, after completely ignoring imminent deadlines for University, I decided to start on my Asuro.
Everything went reasonably well. The manual is clear and the PCB is marked so clearly even I could get it right!
Unfortunately, there is an error in the manual. P13 section 4 states that the R3 resistor should be 470 Ohms, with the colours yellow/violet/black/gold. This is wrong!!!
The reistorshould be a 470 Ohm resistor, but the colours should be yellow, violet, brown, gold.
Apart from that, all I had to do was solder it up and trim the preset resistor. Step 1 complete indeed.
Everything went reasonably well. The manual is clear and the PCB is marked so clearly even I could get it right!
Unfortunately, there is an error in the manual. P13 section 4 states that the R3 resistor should be 470 Ohms, with the colours yellow/violet/black/gold. This is wrong!!!
The reistor
Apart from that, all I had to do was solder it up and trim the preset resistor. Step 1 complete indeed.
posted by The Crusty Old Grognard at 9:57 PM
0 Comments:
Post a Comment
<< Home